Tile Kitchen Countertops : How to Install It?

It will be good to have the tile concept in your kitchen. However, to minimize your spend, can you install it by yourself? Explore your creativity by installing the tile kitchen countertops by yourself. You should apply the thin set first. To attach the backer board to the counter, mix the modified thin set to manufacturer’s specifications, and apply it to the plywood with a notched trowel. Use the flat end of the trowel to push the thin set over the surface of the plywood. Use the notched side of the trowel to comb through the thin set to get a uniform thickness.

tile kitchen countertops

tile kitchen countertops

Lay the backer board. Lay the pre-cut backer board panels on top of the plywood and thin set. Screw the backer board. Screw the backer board into the plywood with backer board screws 6″ to 8″ on center in the field and along all the edges. Once the backer board is adhered and fastened down, tape the field joints with an alkali-resistant backer board tape. (Apply the thin set into the joints, put the tape on top and finish it off with the flat edge of a trowel.) dry run the tiles. To tile the counter top, attach a temporary apron to the counter, and dry run the tiles on the counter leaving a grout joint. Mark with a pencil for chalk lines. On an L-shaped counter, start in the 90-degree corner. Measure the entire counter and chalk the lines. This will determine tile placement and allow you to cut any tile ahead of time. Use a carpenter’s square to draw the lines through the chalk mark.


nice chalking the lines and making the tick marks are done, set the tile in place to cut the sink opening. Align the straight-cut tile with the mark to make the L-cut for the sink. The only difference in the L-cut is that some materials are removed while leaving others. Make the marks on the tile where the sink opening is. Take the other full tile and align it next to the marked tile, and make the same marks on the tile. Make an “x” on the material that needs to be removed when cutting the tiles. Cut the tiles with a wet saw. To apply thin set on the counter, mix the thin set according to manufacturer’s specifications. Pre-wet the backer board with a damp sponge before the thin set is applied. Push the thin set onto the surface with the flat side of a trowel to key the mortar into the substrate. Then, holding the trowel at a 45-degree angle with the notched side down, comb the thin set to a uniform thickness. Start tiling at the apex of the L and work out from there. Make sure the tiles are level and only lay as much thin-set as possible in 15 minutes. Lightly tap the tiles with a rubber mallet. Don’t tap too hard because the tiles could break. If a tile is too high, lightly tap it down, and if a tile is too low, lift it, add some thin set and reset. Don’t forget to clean joints of the excess thin set. Can you install your own tile kitchen countertops now?

Leave a Reply

Your email address will not be published. Required fields are marked *